Samstag, 13. September 2014


After about a week of drying in position, the steam-bent frames were ready to be glued in. First they were given a nice round over on the router.

Rounding-over on the router. I do not have a router table, the small router in the vise works as well..

Round over edges close-up
Frames just before gluing. Cutting them to exactly the correct length to fit snug between the notches in the chine stringers and the cheers stringers turned out to be a bit tricky. I would do that before mounting the sheer stringers next time (as advised Barto's instructions!)

Tape prevents thickened epoxy from messing up the surface.

Keine Kommentare:

Kommentar veröffentlichen